Cisco 300-410 Exam Questions - 300-410 PDF

Latest Cisco 300-410 Exam Questions

We regularly update our Cisco 300-410 Exam Questions, following is the glimpse of the latest 300-410 Exam Questions updated in our Cisco 300-410 Exam preparation products. Buy Cisco 300-410 Exam preparation material listed above to avail full set of updated exam preparation material.

Question 1

Refer to the exhibit.

An engineer configures a static route on a router, but when the engineer checks the route

to the destination, a different next hop is chosen. What is the reason for this?

ADynamic routing protocols always have priority over static routes.

BThe metric of the OSPF route is lower than the metric of the static route.

CThe configured AD for the static route is higher than the AD of OSPF.

DThe syntax of the static route is not valid, so the route is not considered.
The AD of static route is manually configured to 130 which is higher than the AD of OSPF router which is 110.

Question 2

Refer to the exhibit.

An engineer is trying to generate a summary route in OSPF for network 10.0.0.0/8, but the

summary route does not show up in the routing table. Why is the summary route missing?

AThe summary-address command is used only for summarizing prefixes between areas.

BThe summary route is visible only in the OSPF database, not in the routing table.

CThere is no route for a subnet inside 10.0.0.0/8, so the summary route is not generated.

DThe summary route is not visible on this router, but it is visible on other OSPF routers in the same area.
The summary-address is only used to create aggregate addresses for OSPF at an autonomous system boundary. It means this command should only be used on the ASBR when you are trying to summarize externally redistributed routes from another protocol domain or you have a NSSA area. But a requirement to create a summarized route is:
The ASBR compares the summary route's range of addresses with all routes redistributed into OSPF on that ASBR to find any subordinate subnets (subnets that sit inside the summary route range). If at least one subordinate subnet exists, the ASBR advertises the summary route.

Question 3

Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the

configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?

AUse an extended access list instead of a standard access list.

BChange sequence 10 in the route-map command from permit to deny.

CUse a prefix list instead of an access list in the route map.

DAdd this statement to the route map: route-map RM-OSPF-DL deny 20.

Question 4

What is a prerequisite for configuring BFD?

AJumbo frame support must be configured on the router that is using BFD.

BAll routers in the path between two BFD endpoints must have BFD enabled.

CCisco Express Forwarding must be enabled on all participating BFD endpoints.

DTo use BFD with BGP, the timers 3 9 command must first be configured in the BGP routing process.

Question 5

Refer to the exhibit.

R2 is a route reflector, and R1 and R3 are route reflector clients. The route reflector learns the route to 172.16.25.0/24 from R1, but it does not advertise to R3. What is the reason the route is not advertised?

AR2 does not have a route to the next hop, so R2 does not advertise the prefix to other clients.

BRoute reflector setup requires full IBGP mesh between the routers.

CIn route reflector setup, only classful prefixes are advertised to other clients.

DIn route reflector setups, prefixes are not advertised from one client to another.

Prepare Cisco 300-410 Exam

With Implementing Cisco Enterprise Advanced Routing and Services Exam Questions

300-410 Desktop Practice Test Software

300-410 Questions & Answers (PDF)

300-410 Web-Based Self-Assessment
Practice Test

Latest Cisco 300-410 Exam Questions

Prepare Cisco 300-410 Exam

With Implementing Cisco Enterprise Advanced Routing and Services Exam Questions

300-410 Desktop Practice Test Software

300-410 Questions & Answers (PDF)

300-410 Web-Based Self-Assessment Practice Test

Latest Cisco 300-410 Exam Questions

300-410 Web-Based Self-Assessment
Practice Test